vmware view 6.1 teradici pcoip firmware 4.6.1

PCoIP between View Client and Security Server Update the firewall to allow PCoIP to pass through. If remote connections are made directly to the Connection Server then the External URLs must also be setup on the Connection Server.ģ. These names and addresses must be resolvable and usable by the clients. These URLs are used by the View Clients to connect to the particular View server. On every attached Security Server, set up the “External URL” and the new 'PCoIP External URL'. The server used for the PCoIP gateway (usually the Security Servers) must be running View 4.6 or newer on Windows Server 2008 R2.Ģ. Then for all users of this Connection Server and any Security Servers attached, PCoIP will gateway through either the attached Security Servers or this Connection Server. Select a Connection Server, select Edit and tick the box 'Use PCoIP Secure Gateway for PCoIP connections to desktop'. Using View Administrator, go to the Configuration Servers section. That way local access PCoIP can still be direct to the View virtual desktop. If you have some Connection Servers for remote access and some for local access then just do this for the remote access ones. By default, PCoIP connections are direct from the View Client to the View virtual desktop as they were in View 4.0 and 4.5.

Enable PCoIP Gateway functionality on each Connection Server. When View Connection Servers and Security Servers are running 4.6 or newer, you can enable this functionality by following these three steps:ġ. If you're getting these symptoms, then check very carefully that these 3 simple steps have been done correctly. In the vast majority of cases, this was caused because one of the 3 setup steps shown below was not done or not done properly. On the iPad View Client this problem shows as a message saying 'your desktop is loading too slowly'. Some people report that when they setup PCoIP remote access with View 4.6 and try a PCoIP connection from the View Client, they just get a black screen for a few seconds and then an error indicating that the session has ended. See Secure Remote Access with View and PCoIP. I posted an article back in December 2010 in the End User Computing CTO site about this forthcoming View release and described how it works. Starting at version 4.6, View has the ability to support PCoIP remote access through the View Security Server.

Vmware view 6.1 teradici pcoip firmware 4.6.1